The plates to reinforce the rear frame members were simple flat pieces and they all seem to be right on. But the will take a little jockeying around to get them in the right place and firmly attached.
Methinks…
Archives
- July 2011
- May 2011
- April 2008
- October 2006
- March 2004
- May 2003
- April 2003
- March 2003
- February 2003
- January 2003
- November 2002
- September 2002
- August 2002
- July 2002
- June 2002
- May 2002
- February 2002
- December 2001
- September 2001
- August 2001
- July 2001
- June 2001
- May 2001
- April 2001
- March 2001
- February 2001
To-Do List
- Remove old body
- Remove old fuel system
- Tank
- Lines
- Remove brake lines
- Remove engine
- Clean frame
- Wash frame
- Replace front U joints
- Repair frame
- Body Mounts
- Left & Right Rear Frame Members
- Gas Tank Cross Member
- Secondary Cross Member
- Driver Side frame by transmission
- Rider Side front by front end
- Sandblast frame
- Rustproof frame
- Reinstall front end axel and hardware
- Reinstall rear axel
- Reinstall front and rear bumpers
- New brake lines
- New gas tank
- New fuel lines
- Reinstall engine
- Body
- Fix body dents
- Paint body
- Install body
- Install Fenders
- Install Grill
- Install Windshield
- Install Tailgate
- Interior
- Break/clutch pedals
- Dashboard
- Steering wheel
- Seats
- Center console
- Rollbar
- Canvas Top
- Electrical system
- Repair Wreck Damage
- Straighten Frame
- Replace Leaf Springs
- Replace front shocks
- Straighten tie rod
- Straighten & Paint Front Fender
- Replace side marker light
- Get Comprehensive Insurance Coverage
- Winter 2004 Upgrade
- Two Barrel Carb
- Herculiner on floor
- Paint Roll Bar
- Replace starter
- Replace front u-joints
- Reorient air compressor
- Winter 2005 Upgrade
- Two new axels w/ 3.4 gears
- Spring 2006 Upgrade
- New (old) engine!
- Spring 2008 Upgrade
- Roll Cage!
Meta